Philips 231T1LSB-00 - Manual (Page 29)

27 EN
English
‡ Check that the correct channel list is
selected.
No digital channels were found during the
installation:
‡
Check that the TV supports DVB-T or
DVB-C in your country. See the listed
countries on the back of the TV.
Picture issues
The TV is on, but there is no picture:
‡
Check that the antenna is properly
connected to the TV.
‡ Check that the correct device is selected
as the TV source.
There is sound but no picture:
‡
Check that the picture settings are
correctly set.
There is poor TV reception from an antenna
connection:
‡
Check that the antenna is properly
connected to the TV.
‡ Loud speakers, unearthed audio devices,
neon lights, high buildings and other large
REMHFWVFDQLQÁXHQFHUHFHSWLRQTXDOLW\
If possible, try to improve the reception
quality by changing the antenna direction
or moving devices away from the TV.
‡ If reception on only one channel is poor,
ÀQHWXQHWKLVFKDQQHO
There is poor picture quality from connected
devices:
‡
Check that the devices are connected
properly.
‡ Check that the picture settings are
correctly set.
The TV did not save your picture settings:
‡
Check that the TV location is set to the
home setting. This mode offers you the
ÁH[LELOLW\WRFKDQJHDQGVDYHVHWWLQJV
7KHSLFWXUHGRHVQRWÀWWKHVFUHHQ LWLVWRR
big or too small:
‡
Try using a different picture format.
The picture position is incorrect:
10. Troubleshooting
This section describes commonly encountered
issues and accompanying solutions.
General TV issues
The TV does not switch on:
‡
Disconnect the power cable from the
power outlet. Wait for one minute then
reconnect it.
‡ Check that the power cable is securely
connected.
The remote control is not working properly:
‡
Check that the remote control batteries
are correctly inserted according to the
+/- orientation.
‡ Replace the remote control batteries if
WKH\DUHÁDWRUZHDN
‡ Clean the remote control and TV sensor
lens.
The standby light on the TV blinks red:
‡
Disconnect the power cable from the
power outlet. Wait until the TV cools
down before reconnecting the power
cable. If the blinking reoccurs, contact
Philips Consumer Care.
The TV menu is in the wrong language
‡
Change the TV menu to your preferred
language.
When turning the TV on/off/to standby, you
hear a creaking sound from the TV chassis:
‡
No action is required. The creaking sound
is normal expansion and contraction of
the TV as it cools and warms up. This
does not impact performance.
TV channel issues
Previously installed channels do not appear in
the channel list: