InnoMax Scape Adjustable Power Base - Manual (Page 11)

PowerBASE Owners Manual
d. Slide headboard bracket assemblies (in
or out) to achieve a distance of 1.5
inches (38.1mm) to 2 inches (50.8mm)
between the edge of the bed base and
headboard bracket flange assemblies
(
FIGURE 11).
e. Firmly tighten the 3 inch carriage bolts
of both headboard bracket channels.
f. Measure the distance (center-to-
center) between the mounting holes in
the headboard.
g. Measure the center-to-center distance
between the mounting slots of the
headboard bracket flanges (
FIGURE 12).
h. If bracket flange adjustment is required
to accept the headboard, remove the 1
inch headboard bracket flange bolts
and move
flanges side-to-
side for the
adjustment
(
FIGURE 12).
Reinstall bolts
and tighten.
i. Install
headboard.
13. Install mattress on
the bed base frame.
Typical PowerBASE
installation is now
complete. If bed is
equipped with
programmable
settings or options,
refer to the Hand
Control Guide for
programming
information.
INSTALLATION
FIGURE 12: Headboard bracket measurement and adjustment to accept headboard.
MEASURE FLANGE SL
OTS
CENTER-
TO-CENTER T
O CHECK
HEADBO
ARD HOLE L
OCATION
REMOVE 1 INCH BOL
TS AND REL
OCATE
FLANGES T
O ACHIEVE CENTER-
TO-
CENTER DIST
ANCE REQUIRED FOR
HEADBOARD MOUNTING HOLES
FIGURE 11: Headboard bracket position from the edge of the
bed base frame.
1.5 to 2 inches
SLIDE BRA
CKET
ASSEMBLIES IN OR
OUT T
O ACHIEVE
POSITION
9