ARB RD103 - Manual (Page 41)

6 Testing & Final Assembly
39
Figure 28.
6.2.1 A Reinstalling ‘C’ Clip Retained Shafts
c Remove the long cross shaft.
Figure 29.
c Rotate the differential until the ‘C’ clip access window is in full view.
c Insert both axles fully into the housing and gently tap them inward
as far as they will go.
NOTE : To prevent damage to the oil seals, support the weight
of the axle shaft when inserting them.
c Using needle nosed pliers, insert one of the ‘C’ clips onto the
groove in the axle shaft by sliding it between the spider block and a
side gear. (Refer to Figure 30.)
NOTE : You may have to slide the axle shaft outward very
slightly to adequately line up the groove.