ARB RD103 - Manual (Page 7)

1 Introduction
5
1.3 Assembly Type Identification
IMPORTANT:
Sections 2 and 6 of this installation guide have been written to
accommodate two different Dana 35 applications:
A The ‘C’ clip retained axle shaft (Refer to Fig.1.)
B the non-‘C’ clip type axle shaft (Refer to Fig.2.)
To eliminate confusion, you should identify which figure your axle
matches with. The section numbers within the guide that refer ONLY
to the ‘C’ clip type have been suffixed with an ‘
A ’, and those that refer
ONLY to the non-‘C’ clip type have been suffixed with a ‘ B ’.
PLEASE IGNORE ALL SECTIONS WHICH
DO NOT APPLY TO YOUR APPLICATION
Figure 1.
Figure 2.
A
B
‘C’ CLIP