2 b port location on the live axle housing, 3 installing the air locker, Port location on the live axle housing – ARB RD197 User Manual
Page 16
Advertising
3 Installing the Air Locker
14
3.2.2
B
Port Location on the Live Axle Housing
Mark a spot on the top of the outside shell of the differential
housing as shown in Figure 8.
Figure 8.
Cover the drive pinion and axle tube areas with a rag to protect
them from metal filings.
Drill through the housing square to the outside surface using a
11.2mm [7/16”] drill.
Tap the hole from the outside using a ¼” NPT pipe tap.
Remove any sharp edges from the hole that may chip-off and fall
into the housing.
Carefully remove the rags and inspect with a service light inside the
housing to insure no metal filings are left behind.
Advertising