4 installing the air locker, Notching the bearing cap, Air locker final assembly – ARB RD107 User Manual
Page 25
Advertising
4 Installing the Air Locker
23
Figure 16.
4.7.3
Notching the Bearing Cap
c Use a soft jawed vise clamp to hold the bearing cap steady.
c Using a 6.35mm [¼’’] rat-tailed file. File out a notch in the bearing
cap from the closest edge until an adequate notch has been cut
around the position of the punch mark. (Fig.17.).
Figure 17.
c File a chamfer around the inside edge of the notch to remove any
sharp edges from the notch that may chip-off and fall into the
housing.
4.8
Air Locker Final Assembly
Advertising