ARB 3435010 - Manual (Page 3)

25/05/04 Page 3 of 4 3782582
5. Fit the control box bracket to the bull bar using two M6 x 16mm bolts, flat washers and flange nuts.
6. Fit the control box to the control box bracket using the two 1/4” nuts, flat washers and spring washers (supplied
in Warn kit). Centralise the control box in the cut-out then tighten nuts firmly.
NOTE: The gearbox is situated on the left hand side of the bull bar (as viewed from inside the vehicle). The cable
spools from the bottom.
7. Fit the winch and roller fairlead into the bull bar using bolts from the winch kit and four M10 washers from the
ARB bolt kit.
8. Connect the winch control box cables to the winch motor. Refer to the Warn handbook for additional
information. Connect the long winch + & - cables to the vehicle after the bull bar is installed. Refer to the
Warn winch manual for vehicle wiring instructions.
9. NOTE: Ensure that these cables are installed well clear of sharp, hot or moving objects. Secure the winch
cables to the bull bar with the cable ties supplied.
FITTING THE BULL BAR TO THE VEHICLE
10. Assemble the two buffers on to the bull bar using the eight M6 flange nuts supplied.
11. Remove bumper bar from the vehicle. (Refer to diagram 4 for removal details.)
DIAGRAM 4
12. Remove the indicators and number plate from the bumper bar.
13. Fit the number plate to the bull bar using the two M6 x 16mm bolts, flat washers and flange nuts.
14. Remove the chassis extensions from both sides of the front of the chassis. Retain the four bolts and discard
both extensions. (Refer to diagram 5.)