ARB 3435010 - Manual (Page 4)

25/05/04 Page 4 of 4 3782582
DIAGRAM 5 DIAGRAM 6
15. Secure the impact absorber to the front of the chassis using the original chassis extension M10 bolts. Fit the
two 7/16” X 4” bolts through the lower hole in the bracket and finger tighten all the bolts. (Refer to diagram 6.)
16. Lift the bar onto the impact absorber brackets and fasten using the eight M10 x 25mm bolts, flat and spring
washers.
17. Align the bull bar to the vehicle and tighten the bolts retaining the impact absorbs to the chassis to the specified
torque. Drill an 8mm hole in the chassis using the hole in the impact absorber as a guide. Fit the two M8 x
20mm bolts, flat washers and flange nuts and tighten to the specified torque.
18. Fit the indicators into the cut out in the bull bar and connect the indicator looms to the existing indicator loom.
NOTE: Fitting the indicators will be accessed from underneath the bar. Test to ensure the indicators function
correctly.
19. Bolt the air deflector to the underside of the bull bar with the air intake opening facing forward using four M8 x
20mm bolts, flat washers and flange nuts.
TORQUE SETTINGS:
M8 BOLTS 8.6 NM
M10 BOLTS 44 NM