ARB 3434050 - Manual (Page 6)

9/10/01 Page 6 of 9 3782892
10. (If fitting the winch.)
11. To place the winch clutch handle in a
convenient location the winch gearbox must be
rotated 2 hole spacings, 72 degrees, in an anti-
clockwise direction when viewed from the
gearbox end. Place the winch on its end and
remove all gearbox bolts. Gently raise the
gearbox just enough to rotate it. Do not
completely remove the gearbox and avoid
damaging the gasket. Refit all bolts and tighten.
NOTE: Take care not to lift the assembly more
than a couple of millimetres while
rotating to the desired position to avoid
unmeshing the gears.
11. 12. To place the winch motor in the correct location
the winch motor must be rotated 90 degrees, in
a clockwise direction when viewed from the
motor end. Place the winch on its end and
remove the 2 motor retaining bolts. Gently raise
the motor just enough to rotate it. Do not
completely remove the motor and avoid
damaging the gasket. Refit all bolts and tighten.
NOTE: Take care not to lift the assembly more
than a couple of millimetres while
rotating to the desired position to avoid
unmeshing the gears.
12. 13. The roller fairlead must be drilled out using
12mm drill bit, see diagram below. Bolt the
winch and roller fair lead to the bar using the
bolts supplied. The longer bolts are used for the
two bottom holes through the roller fair lead.