ARB 3432060 - Manual (Page 3)

28/10/04 Page 3 of 5 3782592
DIAGRAM1
B. To place the winch clutch handle in a convenient location, the winch gearbox must be rotated 2 hole spacings,
144 degrees, in an anti clockwise direction when viewed from the gearbox end. Place the winch on its end and
remove all gearbox bolts. Gently raise the gearbox just enough to rotate it. Do not completely remove the
gearbox and avoid damaging the gasket. Refit all bolts and tighten. Refer to Diagram 2A.
DIAGRAM 2A DIAGRAM 2B
C. To place the winch motor in the correct location, the winch motor must be rotated 90 degrees, in a clockwise
direction when viewed from the motor end. Place the winch on its end and remove the 2 motor retaining bolts.
Gently raise the motor just enough to rotate it. Do not completely remove the motor and avoid damaging the
gasket. Refit all bolts and tighten. Refer to Diagram 2B.
D. Drill the roller fairlead as shown in Diagram 3 then assemble into the front of the bull bar. Lift the winch into
place and using the 3/8” washers supplied in the fitting kit and the bolts and spring washers supplied with the
winch, bolt securely into position. NOTE: The gearbox is on the LHS. The winch cable spools from the
bottom.
DIAGRAM 3
5. WINCH BARS: FITTING THE 10,000lb WINCH