ARB 3432060 - Manual (Page 5)

28/10/04 Page 5 of 5 3782592
9. Using a 10mm drill and working from underneath the car drill a hole through the underside and top of the chassis
as shown in Diagram 5. Fit the M10 x 130mm bolt, flat washers, spring washer and nut and securely fasten.
10. WINCH BARS ONLY: Wire the winch in accordance with the Warn fitting instructions, taking care not to route
the cables over sharp edges. Tie the cables from the control box to the channel winch mount assembly using the
cable tie supplied.
BULL BAR TO VEHICLE FITMENT:
11. Lift the bull bar into place and loosely bolt to the two Impact Absorbers using the M10 x 25mm bolts, (4 per side)
washers and spring washers. Refer to Diagram 5.
DIAGRAM 5
12. Adjust the bull bar until a uniform gap is achieved to the mud guards and grill. Securely tighten all bolts.
13. Using 10mm hole on rear of upright as template, drill 10mm hole through chassis bracket and secure with 10mm
hardware. This locks bull bar to chassis bracket.
14. Connect the windscreen washer hose to the washer bottle.
15. Connect the bull bar turn signal indicator looms to the existing turn signal indicator loom with the Scotchloks
supplied and test to ensure they function correctly.
16. Trim the plastic inner guard to align with the bull bar and using the hole in the bull bar wing as a guide, drill a
6mm hole in the plastic inner guard and secure with an M6 x 16 bolt and flange nut.