ARB 3450110 - Manual (Page 15)

31 10 02 Page 15 of 16 3783013
50. If no fog lights are not going to be fitted, fit
light surround to bar as is. If fog lights are
going to be fitted, cut out rear of surround using
a key hole saw and remove rough edges with a
file.
51. Fitting of fog light surround housings.
52. Apply a bead of silicon around the fog light
aperture, fit the surround into aperture and
hold to bar using masking tape until silicon
has set, then remove tape.
53. Position for Hi Lift jacking point.