ARB 3450100 - Manual (Page 7)

7-12-04 Page 7 of 10 3782869
(If using bar as a winch bar, follow as per
instructions below.)
19. Fit control box bracket to bar using 8mm
hardware.
20. Fit indicators into bar.
21. Fit number plate bracket to bar upward, or
downward for non winch bar, using 6mm
hardware.
22. Photo on left is number plate bracket in upward
position.
23. To place the clutch handle in the correct position,
the winch gearbox must be rotated 72 degrees (2
hole spacings) in an anti-clockwise direction
when viewed from gearbox end. Place the winch
on its end and remove all gearbox bolts. Gently
raise the gearbox just enough to rotate it. When
the correct position is located, refit all bolts and
tighten.
NOTE: Take care not to lift the assembly more
than a couple of millimeters while rotating to
correct position to avoid unmeshing the gears.
24. To fit roller fairlead to bull bar, you will need to
drill 2 x12mm holes into roller fairlead as per
diagram.
25.Once winch is rotated, position winch on bench
face up.
26. Lower bull bar on top of winch and align holes.
27. Place roller fairlead in bar cutout over lower
holes and fasten using 3/8" Warn hardware and 4
3/8" flat washers supplied in bolt kit.
28. To tighten bolts that hold roller fairlead to bar,
remove vertical rollers using circlip pliers.
29. When all is positioned, tighten all bolts firmly
and replace vertical rollers.