ARB 3450100 - Manual (Page 8)

7-12-04 Page 8 of 10 3782869
30. Fit control box to control box bracket and tighten
firmly.
31. Pull wires through viewer cutout under control
box and wire up as per Warn instruction manual.
32. Tie back cables clear of all moving parts with
cable ties supplied.
33. Place ground earth lead under bolt of winch
tension bar.
34. Fit buffers to bar using 6mm hardware.
35. Lift bar into position between impact absorbers
and bolt up using M10 x 25mm bolts, spring and flat
washers. Finger tighten only. (Bolts fit from inside of
bar.)
36 .Adjust bar so that there is a 15mm gap around the
periphery of the vehicle and securely tighten all
remaining bolts throughout.
37. Next step is to lock pin the bar so there is no
movement by drilling a 10mm hole on both sides
of vehicle, and fasten with 10mm x 25mm bolts
plus 10mm hardware.
38.Wire main power leads to battery as per Warn
instructions and cable tie leads securely from all
moving parts with cable ties supplied.
39. Fit number plate to bar using 6mm hardware.
40. Pull winch cable through roller fairlead, and fit
tow hook.
41. Connect the indicator looms to the existing
indicator loom with the Scotchlocks supplied. Test to
ensure the indicators function correctly.
42. Drill out plastic inner guard panel with 6mm drill
bit using holes in bar return as template.
43. Secure with 6mm hardware.
Photo above shows cable ties holding leads in place.
Photo is from RHS of vehicle.
Photo is from LHS of vehicle.