ARB 3450210 User Manual
Page 5
Last Rev Date: 25 01 08
Page 5 of 11
Fitting instructions# 3786376
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
2. This is how the vehicle must be
prepared before fitting a bar to the
vehicle.
3. Arrows indicate which bolt holes to
use when fitting the bar to the
vehicle.
4. The set of mounting holes under
arrowed holes are for vehicles that
have been fitted with a body lift kit.
I.e. This set of mounting holes will
lift the bar 25mm.
5. If a winch is going to be fitted, the
right hand side mounting plate on
end of chassis has to be notched for
winch clearance.
6. Cut top flange up to chassis rail
and 15mm in.
15MM IN
UP TO CHASSIS RAIL
VIEWED FROM RHS OF VEHICLE
SIDE MOUNTING