ARB 3450210 User Manual
Page 7
Last Rev Date: 25 01 08
Page 7 of 11
Fitting instructions# 3786376
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
11. Pass caged nut plate from top
through crossmember, then upwards
into open end of chassis rails.
12. When all bolts are tighten to
correct torque, brake off the part of
the captive nut plate which hangs
through the hole in vehicle
crossmember with a pair of pliers.
13. If a number plate is to be fitted to
vehicle, you must assemble as per
photo opposite.
14. To assemble, using a 6mm x 25mm
bolt, flat washer, pass through
outer frame, fit black nylon packer
then pass through inner frame and
secure using a 6mm nyloc nut.
15. Tighten just enough so the
assembly can pivot.
16. The reason for a pivoting number
plate assembly is to allow the
number plate to pivot up when the
winch is being operated.
TOP VIEW LHS OF VEHICLE.