ARB 3450210 User Manual
Page 9
Last Rev Date: 25 01 08
Page 9 of 11
Fitting instructions# 3786376
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
27. If a Power Plant 9500LB –
12000LB is going to be used. The top
compressor cover must be removed
by undoing the 4 capped head
screws.
27. Place protective cloths over top of
bar and lift winch onto winch
mounting platform.
28. Refit top cover.
29. Secure and wire up the same
method as paragraph 21-22.
30. Winch has built in control box
feature, therefore no control box
bracket required.
31. Lastly, fitting a TI 9500LB winch,
is same as paragraph 21-22-30.
32. If fitting lights to bar, the light
mounting brackets must be fitted
at this stage.
33. The brackets is bolted to bar
using 8mm hardware and secured
using a 8mm nyloc nuts.
34. The bracket faces towards the
winch so when the lights are fitted
the high lift jack, if used, does not
hit the light.
35. If lights are going to be fitted to a
bar fitted with a power plant
winch, the brackets face
outwards, therefore a hi lift jack
cannot be used.
Hold nylo c nut
Using ¼” drive
Ratchet with
extension