ARB 3462030 - Manual (Page 10)

Last Rev Date: 3/4/06 Page 10 of 12 Fitting instructions# 3783194
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
31. Fit control box to bracket.
32. Remove cover off control box. Supplied in
fitting kit are 2 x black and 1 x red 460mm
extended cables, mark these accordingly with
the F1, F2 (black) and A (red) markings from
original cables. Remove the 3 x shortest
original heavy duty cables and connect the
extended cables taking care that the
connections are per original configuration.
33. Route and connect the winch control box
cables to the winch motor, taking care that
the cables are connected to the
appropriate terminals. Refer to the Warn
handbook for additional information. Connect
the long winch + & - cables to the vehicle
after the bar is installed. Refer to the Warn
winch manual for vehicle wiring instructions.
CAUTION: The next step is best achieved
using a safe lifting device or with the help of an
assistant. If a winch is fitted two assistants are
recommended.
34. Fit the bull bar to the vehicle mount brackets.
Use the M12 fasteners to secure it and make
adjustments so there is approximately 20mm
gap from under the grille to the top of the
wing.
35. Tighten the M12 fasteners.
34. Drill and pin the bar to the mounts in 2 x
places per side using M10 drill bit, as shown,
then bolt up using M10 x 30 SEMS bolts and
flange nuts.
F2
black
A Red
F1
Black
20mm gap
Warning: Drilling operations can result in
flying metal debris, safety glasses should be