ARB 3462030 - Manual (Page 5)

Last Rev Date: 3/4/06 Page 5 of 12 Fitting instructions# 3783194
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
5. Remove bumper. Undo any electrical
connections to lights in bumper. Undo two
bolts per side retaining the bumper stabilising
bars to the chassis. Loosen only the two
bolts securing the stabiliser bars to the
bumper, the bars should now be able to
swing away from chassis. Undo the three
bolts per side securing the bumper mount
brackets to the chassis. Remove bumper.
6. Remove tow hooks, these will not need to be
refitted.
7. Remove plastic trims from lower front of
guards. At the indicated cut line (along the
moulded feature line approx. 23mm from top
face) cut and retain the lower section of these
trims. Deburr, if necessary touch up and refit
the trims.
NOTE: IF THE CHASSIS IS 2500/3500 THEN FIT
ADDITIONAL BRACKETS AS SHOWN IN STEPS
8 & 9, OTHERWISE PROCEED TO STEP 10.
8. Insert the brackets (note they are handed)
with the short end inside chassis first and the
large flange closest to the centre of the
vehicle.
9. Insert the nut plate and then insert M12 bolt
and washer sets but do not screw the front
most bolt past the end of the nut. Leave
bolts loose.
NOTE: RHS bracket shown