Fast & Fluid AT750 - Manual (Page 12)

p12
© Fast & Fluid Management, EuroAT
B - Dispensing
Step 1 - Bring can to correct position
> >
Place the can at the right
place of the can table. Use
the 3 LED-spots to check if
the can is in the right
position. If the electrical can table
option is installed: move the
can table upward by
pres-sing the can table switch
on the keyboard support. The upward movement will
stop automatically.
This is the optimal height for
dispensing.
> >
For safety reasons the can
table will not move upwards
without the nozzle guard in
right position! If the manual can table
option is installed: hold the
can table and unlock the
index pin.
Lift the can table until the
can is in reach of the can
sensor. The can should be
just below the nozzle guard.
Release the index pin. Gently
release the can table.