Fast & Fluid AT750 - Manual (Page 16)

p16
© Fast & Fluid Management, EuroAT
Troubleshooting
A - Introduction
Before calling your machine supplier or Service Department, please check whether you can solve the problem
yourself. If you cannot, then call the Servic e Department for advic e. Have the model number and serial
number at hand (these can be found on the silver CE sticker at the service panel at the back of the m achine).
Use the Problem Solving chart below to judge whether you c an solve a problem yourself or not. The tool
symbol (
) means you cannot solve the problem yourself and the Service Departm ent must be called. On no
occasion remove side panels yourself, this may only be done by trained service personnel. This c hart does not
include any of the malfunctions which are reported in an error message by the software. In the event of a
malfunction, these messages and possible solutions are displayed on the m onitor.
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power
before accessing moving parts.
B - Problem solving
Symptoom Cause Action
Nozzle leaks through the outlet
opening Air bubble in pump Prime the pump
Pump is defective
Replace pump
Canister connection leaks
around the suction point
Worn O-ring(s) Replace O-ring(s)
Air is being fed together with
the paste Air bubble in the pump Prime the pump
Canister is empty Refill canister
(New) software is not working Program not correctly booted Reboot computer & software
Software incorrectly installed Reinstall software
No power from power unit Not connected to power grid Check power cables
Fuse blown
Remove plug from socket, replac e
fuse
Colours are difficult to
reproduce Mechanisms are dirty Clean and oil
Quality fluctuations in paste supplied Contact paste supplier
One or more pastes have thickened Replace paste(s)
Poor monitor picture, or no
picture Monitor is switched off Switch monitor on
Loose cable(s) Check cables
Picture set too dark Adjust picture correctly
Monitor malfunctioning
Keyboard is not working Loose cable(s) Check cables
Windows Regional setting is inc orrect Check Windows software manual
Defective cable(s)
Keyboard is defective
Stirrer is not rotating Top lid not closed properly Close top lid
Timer setting incorrect
Use the software to set the
timer correctly
Loose cable Check cable
Defective cable
Defective motor