Fast & Fluid TM300 - Manual (Page 4)

Warranty regulations
In these warranty conditions, ‘F&FM’ is understood to mean Fast & Fluid Management. The warranty
conditions incorporated into F&FM’s general conditions of sale are summarized as follows (for free general
conditions you can contact F&FM):
F&FM guarantees the proper operation of any goods which it supplies, for a period of one year, except
where a breakdown is the result of normal wear and tear. The cost of any inspection activities carried
out by F&FM, with the aim of establishing whether or not a breakdown is covered by the warranty will
be reimbursed by the other party if it transpires that the breakdown is not covered by the warranty. If
it transpires that a breakdown is covered by the warranty then F&FM will supply identical or equivalent
goods under the conditions referred to in point 6 of the general conditions of sale. The warranty obligation
described in this article only applies if the goods supplied by F&FM have been used in accordance with the
manual. Time spent on warranty-related activities, including travel time, travel costs and accommodation
costs, are charged at current rates.
In contrast to the above, F&FM will not be held to any warranty obligation if:
1. Repairs have been carried out, or attempted, by the other party or a third party, unless F&FM had
previously declined to repair the goods for a fair price;
2. F&FM demonstrates that the defect did not emerge during testing;
3. The other party fails to inform F&FM of the defect immediately, if possible either by letter and/or by
fax, providing full, accurate details and/or has failed to comply fully with F&FM’s instructions;
4. The other party has failed to use or treat the goods properly or in accordance with F&FM’s instructions;
5. The damage has been caused by incidents, beyond F&FM’s supervision, which have occurred either
during transport or installation.
In the following text, the expression “Software” will be understood to mean the standard computer soft-
ware supplied by F&FM to the other party, recorded on a computer-readable storage medium, plus the ac-
companying documentation (Software Manual) and including any improved and/or new versions supplied.
The expression “processing unit” (PU) is understood to mean the machine for which and with which the
Software is supplied, and which is the sole machine on which the Software may be used.
The other party is authorized to copy the Software either in its entirety, or in part, (up to a maximum of 2
copies) for purposes of internal security. These copies will be furnished with the same marks, designations
relating to copyright and other registration numbers as the original version of the Software.
The other party will neither amend, translate, decompile nor adapt the Software, nor convert it into sour-
ce code, without express written permission from F&FM. If the other party so requests, F&FM will provide
that party with the information required to render the Software interoperable with other software.
In the event that the PU experiences a breakdown, the other party may use the software on another
processing unit until the PU is again operational. The other party will inform F&FM of this within 5 days.
If it is a requirement that the Software be defi nitively transferred from the PU to another processing unit
then the other party shall request permission from F&FM, which will not withhold such permission on un-
reasonable grounds.
4
Introduction
By selecting a Fast & Fluid Management Color Dispenser you have opted for a product which is the result
of intensive research. Top-quality components, craftsmanship and a modern ergonomic design all serve to
guarantee a long service life and a high degree of user friendliness.
The machine complies with Council Directives on machines, on electromagnetic
compatibility, and on electrical equipment intended for use within given voltage limits, as enacted
by the Council of Ministers of the European Community. The machine is furnished with a CE mark.