Fast & Fluid TM300 - Manual (Page 9)

9
Operation
Switching ON:
Unlock the emergency stop button on the front of
the machine by turning clockwise. The machine is
automatically switched on when the power con-
nector at the back of the dispenser is plugged into
a 220V or 110V wall socket.
Please be aware that the TintMaster series
dispensers are fi tted with sleeping timers as
standard. This means that after approximately 30
minutes the dispenser will enter a power saving
modus in which all secondary units (e.g. sensors)
are switched off automatically.
Stirring is not affected by this modus. To awake
the dispenser from its sleeping modus, perform
any command from the dispensing software or
press either of the can table buttons.
Switching OFF
Please note that with normal operation there
should be no reason to take the power off the
dispenser. In case the dispenser must be
switched off, there are several ways of achieving
this:
1. Shut down the computer and unplug the power
connector at the back of the machine.
2. Shut down the computer and switch the
internal power socket behind the bottom service
panel at the front of the machine.
3. Shut down the computer and press the
emergency stop button.
>
Caution! Switching off the dispenser with the emergency stop switch will also cause
the stirring mechanism to be turned off.
Agitation timer
The stirring time and interval can be altered from
its default settings*. This can be done through
the dispenser software, check your software
manual for instructions.
Please ask your paint supplier for optimal
agitation settings for your specifi c colorant
products.
* Default value is 180 seconds of agitation every
3 hours.
>