BNC 7000 Series User Manual - Manual (Page 13)

13
2.4.10 Shutting Down the SERIES 7000
Press the Line on/off switch on the rear panel to power off.
2.4.11 Perform Firmware Upgrade
A firmware upgrade of the SERIES 7000 can be done directly via the GUI. Make sure you are
connected to the right device and have the correct firmware binary ready. Then go to Device 
Update Firmware and select the appropriate binary (tar.file) that you have received from Berkeley
Nucleonics or downloaded from the Berkeley Nucleonics website. The update will take a few seconds,
and after completion the device will reboot. Reconnect to the device and continue using the device.
Caution:
Do not switch off instrument or disconnect during upgrade procedure.
2.4.12 Serial Number
Each instrument owns a unique serial number which is shown on the sticker on the rear panel. This
serial number is also internally stored and determines the instrument configuration and guides the
software accordingly.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com