9 fft analyzer measurement – BNC 7000 Series User Manual User Manual
Page 45
Advertising
45
3.9 FFT Analyzer Measurement
This tab is used to measure noise on one or two channels of the FFT analyzer. Select the frequency
range and the number of averages. Under “More” select either “Single Channel” or “Two channel
cross-correlated” measurement. Press start button to run measurement.
Figure 19 FFT Analyzer Mode
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web:
Advertising