Hyline Offroad JK LOUVERED HOOD PANEL - Manual (Page 2)

If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now
before installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING
BEFORE PAINTING OR FINISHING (If Necessary). If Hood Louver Panel was was ordered
black powder coated your now ready to continue to step 1.
Hood Louver Panel Installation
Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting.
First, remove the engine grounding strap using 10mm Socket, hood light, and/or windshield
washer hose from hood. Then unbolt the 4 Torx bolts from the hood hinges using the T-50
Torx. Hood should now be free to remove from vehicle.
Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove u-shape
tie down bracket using the 9mm Socket. You do not need to remove the windshield
bumpers or the washer nozzel.
Step 3 – Place painters/masking tape either on the hood or backside of the steel template to prevent
any scratching.
Step 4 – Place one piece steel template in the center of hood as
Q:\Hyline Offroad, LLC\Installation Instructions\JK-50HLP\JK-50HLP Installation Instructions.doc
Page 2 of 5
REV 0 8/6/10
Figure 1