Hyline Offroad JK LOUVERED HOOD PANEL - Manual (Page 3)

shown in (Figure 1). Reinstall the u-shape tie down
bracket. This will locate the template in the
appropriate location.
Step 5 – Using 3/16” Bit, drill one hole through the template
and hood at one corner, as shown in (Figure 2).
Install and tighten the supplied 10-32 screw and nut.
Then drill a second hole in the opposite corner of
template and install and tighten supplied 10-32 screw
and nut. This will ensure template stays in place
while drilling and cutting.
**Important** DO NOT MOVE TEMPLATE UNTIL STEP #7
Q:\Hyline Offroad, LLC\Installation Instructions\JK-50HLP\JK-50HLP Installation Instructions.doc
Page 3 of 5
REV 0 8/6/10
Drill & Install first 10-32 screw
here in upper left corner.
Figure 2
Drill & Install second 10-32
screw here in the hole above the
corner hole.