Rock-Slide Engineering RAPTOR – STEP SLIDER - Manual (Page 8)

Installation Instruction RSEI 119
4. Position the control box under the rear seat or near the back of the cab, anywhere out of
the way where the wiring harness will fit to both sides of the truck.
a. Choose a location out of sight and in a secure spot so it will not come into contact
with anything or be kicked by a rear seat passenger
5. Plug the harness into the control box and lay the harness wire into position in the truck
starting on the rear passenger side
a. You will want to divide the harness between the rear seats, the front passenger
seat and finish with the driver door. This will reveal how you will be able to
conceal the harness under the carpet when your done
6. Once the harness is positioned in its proposed layout you will need to gain access to the
slider outside the truck to power the slider.
7. Starting on the rear passenger side, run the actuator wires up through the floor of the
vehicle. THIS MAY REQUIRE YOU TO DRILL AN ACCESS HOLE DEPENDING ON MODEL
AND YEAR. Connect the red/black connector on the wiring harness.
a. Secure wires to minimize slack so they are protected. We recommend zip ties
b. *Optional: The pink/tan wire is used if LED light package is being installed
8. Inside the truck, route the rear passenger door sensor wire along the doorframe; and
using a sticky pad, mount the sensor underneath the door latch
a. Pull the rubber door seal away from near the latch and run the sensor wires
under the seal.
b. Connect the blue/white wire to the door sensor
c. Place a small piece of electrical tape on the sensor wire to secure the wire from
the truck and protect it on the metal seam
9. While moving to the front passenger door, run the harness under the door sill. Just as
for the back door, route the front passenger door sensor wire up near the latch and
under the door seal.
a. Connect the green/grey wire to door sensor
b. Place a small piece of electrical tape on the sensor wire to secure