J.P. Instruments EDM 730 Fuel Flow Installation Manual - Manual (Page 2)

J.P.Instruments Fuel Flow Installation Manual
Report # 503
for EGT-701 with Fuel Flow Option Page 2 of 14
Rev B : Date 03/14/97
EGT-701 with Fuel Flow Option
Installation Instructions
1…General:
A complete thorough familiarization and understanding of the system and this manual is necessary before commencing
the installation. All work must conform with A.C. 43.13.1A ch. 11 sec. 2, 3, 7. The accuracy of this instrument
depends entirely upon the accuracy of the data entered. A periodical checking of the actual fuel onboard will eliminate
the accumulation of errors due to evaporation leaks, etc.
Do not use the FXT-201 Flow Transducer on aircraft with a gravity feed system . The standard Fuel
Transducer (FXT-201) shipped with the EGT-701(),with Fuel Flow option Fuel Flow instrument is intended to be used
on aircraft equipped with fuel pumps. A gravity feed system requires the FXT-231 flow transducer.
Transducer Identification Markings
FXT-201 - Marked "20 l " on the top of the unit.
FXT-231 - Marked "231" on the top of the unit.
Installation of the EGT-701(),with Fuel Flow option on an aircraft with a fuel return line from the Carburetor
requires a FFDM-1, -2 Differential Module manufactured by from EI or JPI.
The placard "Do Not Rely on Fuel Flow Instrument to Determine Fuel Levels in Tanks" must be mounted on the
aircraft instrument panel near the EGT-701, ( ) with fuel flow option.
If the aircraft is equipped with a primary fuel flow, the following placard must be mounted on the aircraft
instrument panel near the EGT-701(),WITH FUEL FLOW OPTION( ): "Refer to Original Fuel Flow
Instrumentation for Primary Information".
do not obstruct the freedom of travel of arty controls.