J.P. Instruments EDM 740 Pilots Guide - Manual (Page 43)

For Your Safe Flight Page 43
Scanner Parameter Example Table
Switch Parameter Example Comments
T, A Voltage, System Bus 14.2 BAT Battery voltage
T, A Outside Air Temp 81 OAT °F or °C
T, A Induction Air Temp 125 IAT Out of intercooler
T, A Compressor Discharge
Temp 300 CDT Out of compressor
T, A Intercooler efficiency 25 C-I Amount of cooling provided
by the intercooler (if
equipped)
T, A Carburetor Temp -22 CRB Not available when CDT is
installed
T, A Difference between
hottest and coldest EGT 80 DIF Dot indicates most widely
deviating cylinder
T,A,F RPM MAP for 1 sec RPM 2450 MAP 23.4 RPM and Manifold pressure
F, A Fuel Remaining CALCULATED
37.2 REM
In gallons, liters or pounds
or kilograms
F, A Fuel required to next
GPS WPT or
Destination
25.9 REQ
Present with GPS interface
Valid signal and way point
F, A Fuel Reserve at next
GPS WPT or
Destination CALCULATED
11.3 REM
Present with GPS interface
Valid signal and way point
F, A Nautical Miles per Gal
13.0 MPG
Present with GPS interface
and valid signal or
MPK,
MPL, MPP
F, A Time to Empty CALCULATED
02:45 H:M
Hours: Minutes Remaining
at current fuel burn
F, A Fuel Flow Rate 13.5 GPH Or KPH , LPH , PPH
F, A Total Fuel Used 26.5 USD Since last refueling or trip
total.
T, A EGT, CHT EGT 1340 CHT 376 EGT, left, CHT, right. Dot
indicates cylinder
T, A TIT, Turbine Inlet Temp 1 1370 TIT Turbine Inlet Temp #1
T, A TIT, Turbine Inlet Temp 2 1340 TI2 Turbine Inlet Temp #2
T, A Oil Temp 178 OIL-T Oil Temperature
T, A Oil Pressure 52 OIL-P Oil Pressure
T, A Shock Cooling -30 CLD Cyl. I.D. box indicates
fastest cooling cylinder