J.P. Instruments EDM 740 Pilots Guide - Manual (Page 45)

For Your Safe Flight Page 45
The EDM will show messages and percent complete indicators to keep
you apprised of progress. When the download is complete the EDM may
briefly show
DONE . Wait a few seconds for the display to return to the
normal engine monitoring mode and then remove your USB Drive. This
completes the download.
Transferring from the USB Flash Drive to a PC
To transfer your data from the USB flash drive to your PC, follow these
easy steps.
1. On your PC, start the EzTrends program.
2. Plug in the USB flash drive into an available USB port.
3. In EzTrends, select the Move and Plot Data from Memory Stick
option.
4. In the displayed list, find the USB flash drive and double click it.
5. Select the file you wish to plot and then select the flight in that file.
Refer to the EzTrends manual for details on how to use EzTrends.
Section 6 - Personalizing
Pilot Programming
To start the Pilot Programming Procedure, simultaneously hold the
STEP and LF buttons for five seconds. You will see the word
PROGRAM for two seconds and then the sequence shown in the chart
below. Tap the STEP button to advance to the next item in the list. Tap
the LF button to select alternate values of that item. The shaded areas in
the example chart below pertain only to the Fuel Flow Option.
Tap STEP to
advance to
the next item
Tap LF to
sequence
through
these values Comments
PROGRAM Briefly indicates entry into Program Mode.
FUEL? N N
 Y Y—Yes—to change fuel status. See
refueling.
RATE 4 0 … 9 Index rate (pause time) in the Automatic
Mode. 0 disables the Automatic Mode. Tap
‘STEP’ to accept and go to next mode. Hold
STEP and LF to access ‘ORIG T ? N’.