AEM 30-1931 Universal Fuel Ignition Controller 8 Channel - Manual (Page 8)

Page 8
Connect all three F/IC grounds. See Figure 12.
ECU
FIC
POWER GND TO GROUND
PWR
GN
D
GROUND CONNECTION
TO GROUND POWER GND
PWR
GN
D
TO SIG GND SIGNAL GND
SIG G
ND
Do you want to use the Switched 12 volt dc source from the F/IC?
If so, connect the
“Switched 12 Volt” source wire as shown below. (Note: The
driver can handle 1 amp Max.) See Figure 13.
LOW CURRENT
RELAY/SOLENOID
SWITCHED 12 VDC CONNECTION
FIC
SW
12
Figure 12. Power Ground Connections
Figure 13. Switched 12Vdc Connection