AEM 30-1931 Universal Fuel Ignition Controller 8 Channel - Manual (Page 9)

Page 9
Do you want to use the Auxiliary Gauge in the F/IC?
If so, connect the
“Auxiliary Input” as shown below. See Figure
4.
UEGO
FIC
0-5V OUT
AUX
IN
AUXILIARY GAUGE CONNECTION
Do you want to use the F/IC’s Internal Data Logger or the Dual Calibration mode?
If so, connect the
“Switch Input” as shown below in Figure 15.
Do you have a frequency based MAF sensor (Karman Vortex or Delphi)? Or, do
you want to recalibrate your speedometer? (Note: The frequency channel can do
one or the other, not both.) Connect the frequency channels as shown below in Figure
16.
Figure 15. Switch Input Connection
Figure 14. Auxiliary Gauge Connection
Figure 16. Frequency Channel Connection