AEM 30-3433 Series 2 AEMnet Adapter - Manual (Page 3)

Page 3
REMOVE EXISTING WIRES FROM ECU PLUG(S)
1. Locate a small screwdriver (a precision 1.5mm wide flathead screwdriver is recommended)
and carefully pry yellow plastic retainer using both slots in the retainer so it disengages
vertically about 1mm as shown in figure 2:
Figure 2: Pry in this area to remove cover
2. Next remove the pin from the plastic connector by lightly prying on the plastic tabs that
secure the pin in the plastic connector while gently pulling on the wire at the same time as
shown in figures 3 and 4.
Figure 3: Pry this tab up with the screwdriver or paper clip to release pin