JB Conversions 2800 LoMax 205 - Manual (Page 18)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 17
337-625-2379
337-626-8365 fax
www.jbconversions.com
34. Remove the original gear from the shaft. The needle bearings may fall off of the shaft as you lift
the gear.
35. Inspect the lower thrust washer and replace if necessary.
36. Install the needle bearings onto the rear output shaft (above the thrust washer) using grease to hold
them in place. Notice there are two rows of bearings with a spacer in between the two rows. Wipe
the bore of the new LoMax gear with gear oil and slide it onto the front output shaft.