JB Conversions 2800 LoMax 205 - Manual (Page 21)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 20
337-625-2379
337-626-8365 fax
www.jbconversions.com
43. Apply RTV to the mounting face of the steel bearing housing. Use a gasket if you wish.
44. Lower the output shaft assembly onto the case. Make sure the clutch teeth on the output gear
engage with the slide ring internal teeth.
45. Bolt the steel housing to the new case (20-40 ft-lb.).
46. Bolt the tail housing onto the rear bearing housing (20-40 ft-lb.).
47. Install the poppet balls, springs, and threaded caps.