JB Conversions 2800 LoMax 205 - Manual (Page 4)

LoMax™ 205 – Case and 3:1 Gear Set
JB Conversions, Inc. Page 3
337-625-2379
337-626-8365 fax
www.jbconversions.com
8. Remove the slider ring and the high range front output gear from the case. Then remove the two
hex caps in the top of the case followed by the springs and detent balls. You can use a magnet and
punch to remove the balls which are located below the springs.
9. Use a punch to drive out the two
” shift rail pin access hole plugs. They will fall into the case
and can be removed and discarded. You may need to move the shift rails to line up the roll pins
with the holes in the case. Use a small tipped punch to drive the roll pins inward and out of both
shift forks.
10. Remove the short shift rail followed by the long shift rail. You may to rotate the rails either
direction while pulling them through the forks. Steady each fork from within the case as you pull
the rail from outside the case.