Apple PowerBook Duo Dock (including Duo Dock II) - Manual (Page 27)

Installing a NuBus card
Installing a NuBus card in the Duo Dock is a technically challenging procedure. W
e recommend that you attempt it only
if
you are comfortable working with electronic equipment. Y
ou
should read all of the following instr
uctions before you begin. If
the procedure sounds lik
e something you don
’t want to do
yourself
, any Apple-authorized ser
vice provider can install a
NuBus card for you. Getting ready You need the Duo Dock, a NuBus card, and a flat-blade screwdriver
.
v
If your system is already set up:
Tu
rn
off
, disconnect, and
remove all equipment attached to the dock, but do not unplug the power cord that connects the dock to an electrical outlet or power strip.
v
Installing the card
1.
Unlatch the top cover of the dock by pinching the grooved sur
face just inside the front opening.
2.
When the latches r
elease, tilt the cover upwar
d slightly
(to about a 30°
angle) and then lif
t the angled cover
straight up to r
emove it.
continues
.
This
Not This
23