Apple Soundtrack Pro 2 - Manual (Page 512)

512 Appendix D Working with Apogee Hardware in Soundtrack Pro
 Meter Display pop-up menu: This pop-up menu determines the type of metering
displayed by your units. Options are input level, output level, or no signal at all. If you
select the Hold Overloads checkbox, your hardware displays overloads permanently.
Clicking the Clear Overloads button (alongside the Meter Display pop-up menu)
resets the overload LEDs of your meters.
 CD Mode checkbox: Selecting this checkbox turns on CD mode, which sends a
44.1 kHz, 16-bit stereo signal to the S/PDIF output, regardless of the input. In effect,
selecting this checkbox automatically switches the Conversion pop-up menu to
S PDIF Out, the Sample Rate pop-up menu to 44.1 kHz, and the UV22HR pop-up
menu to S/PDIF Out. If any of these automatically set parameters are then changed
manually, the CD Mode checkbox is automatically disabled.
Inputs Tab
This tab is used to configure the inputs of your Apogee hardware. The tab contains four
identical parameter sets for microphone inputs 1 to 4 and a parameter section for line
inputs 5 to 8.