Apple Server Diagnostics - Manual (Page 34)

To do this Do this
Choose which tests are run Do any of the following:
 To select a test, select the checkbox next to
the test.
 To select a specific test within a category of
tests, click the disclosure triangle next to the
category, and then select individual tests.
 To select all tests, click Select All.
 To remove all tests, click Deselect All.
Loop all selected tests Do one of the following:
 To loop all selected tests a specific number of
times, select “Loop # times” and replace # with
the number of times to loop.
 To run all tests once, select “Loop # times” and
replace # with the number 1.
 To loop all tests for a specific amount of time,
select “Loop for # hours and # minutes” and
replace # with number of hours and minutes
to loop. When the specified time is reached,
the current loop must complete before the
tests stop. For example, if one loop of your
test set takes 2 hours to complete and your
specified time is 3 hours, Server Diagnostics
stops testing in 4 hours. (Instead of stopping
at 3, it waits for the current test set loop to
complete before stopping.)
Change what to do when an error occurs In the On Error pop-up menu, do one of the
following:
 To stop testing when the first error occurs,
choose Stop.
 To continue testing when errors occur, choose
Continue.
2 To run the test, click Test.
Clearing the Test Log
The test log contains all test messages that have occurred during the current Server
Diagnostics session. If you quit Server Diagnostics, the log is cleared.
To clear the test log without quitting Server Diagnostics, click Clear Test Data.
Viewing the Hardware Profile
The hardware profile lists all hardware components in the server.
You can view the hardware profile by choosing Hardware Profile > Display Hardware
Profile.
34 Chapter 4 Using Server Diagnostics