Lukas SC 357 E2 User Manual
Page 29
29
H
J
H
J
K
M
M
L
D
G
5. Remove self-locking nut D and push the
pivot bolt G out.
6. Remove the retaining rings H and
push out bolt J.
7. Now, you can remove blade K and
sliding plates L.
8. Fold in the lever elements M.
10. The work steps must be carried out in reverse order to fi t the new parts.
E
ATTENTION!
Don’t forget to apply LUKAS special grease to all sliding surfaces.
ATTENTION!
The nut of the pivot bolt and the pivot bolt itself are matched by a special
procedure. Therefore they must only be changed as a set by using a new set!
Because of the special procedure used, unscrewing of the nut while working will
be minimized and a resulting blade crack will be prevented.
The nuts can be unscrewed and tightened up to 10 times without affecting the
service performance!
NOTE:
The torque required
can be taken from the spare
parts list of your particular
unit.
9. Last of all, pull the protective sleeve "E" off the
device, as shown above.