Synergy 5051 - Front 3 Link Kit for Jeep TJ User Manual
Page 7
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
15. Reinstall and tack weld the control arm brackets on the frame. Double check the
front to back location and make sure they are the same side to side.
AXLE LINK BRACKETS
16. Cut off all or any unwanted suspension brackets from the axle housing. Use a grinder
with a cut off wheel, plasma cutter or oxy-acetylene torch. Grind the welds smooth.
17. It is best to set the axle on jack stands with a jack supporting the pinion to set the
castor angle. Adjust the castor to your desired castor, 6-8 degrees is typical for this
type of application.
18. Position the lower control arm brackets on the axle tube. These brackets are made for
a 3" axle tube, you may need to modify them to fit your axle tube if it's a different
size. This is not a set location and is up to you to find the optimum position.
Typically the lower control arm brackets are as far apart on the axle housing as
possible without the tire contacting the lower control arms at full turn. The lower
control arm brackets are usually anywhere from 2" to up against the inner C weld.
The top of bracket is typically level to the ground. Make sure the angle inward
looking from the top.