Synergy 5051 - Front 3 Link Kit for Jeep TJ User Manual
Page 8
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
19. Mock up the single upper control arm mount (may require fabrication or purchase of
an axle bridge for over the diff housing). Do not weld entirely to a cast diff housing,
it will not hold. The side to side location is usually pretty tight so you may want to
wait until you place the axle back in the vehicle to finalize this mount.
LOWER CONTROL ARMS
20. Position the axle housing back under the vehicle on jack stands. Set the front to back
location and set the axle at ride height and correct castor angle based on your notes
and dimensions from the beginning.
21. Measure center to center of the bolt holes of the lower control arm brackets. This will
be the length of the lower control arms. Thread the rod ends or Johnny Joints with