Snorkel X33BE-sn10131+V-1 - Manual (Page 59)

1. Check to be sure the Battery switch ƒ is
ON. (See Figure 9.4)
Figure 9.5
2. Check to be sure the Emergency Stop
switch „ (see Figure 9.5) is on (up).
3. Check to be sure the Main Power switch
is on (see Figure 9.5).
4. Check to be sure the Selector switch † is
set to platform (up) (see Figure 9.5).
5. If the Battery Switch ƒ (see Figure 9.4),
Emergency Stop „, Main Power , and
SELECTOR switch † (see Figure 9.5) are
all set correctly, and the engine will not start
from the platform control box, set the
Selector switch † to ground (down) and try
to lower the platform from the ground control
box.
Pinching And Crushing Hazard. At the next
step the platform will come down and the
scissor arms will close. Keep all body parts
out of the scissor arms and out from under
the platform.
Figure 9.6 - Manual Bleed Down Control
6. If the platform will not lower, the person on
the ground will need to use the manual bleed
down ‡ (see Figure 9.6) located at the front
of the chassis.To lower the platform pull on
the cable ‡) until the platform is fully
lowered.
NOTE
If the platform does not come down, refer the
problem to a qualified trained service technician.
■ Pushing / Towing
An RT can be safely pushed or towed by hand on
level firm sur faces. To do so:
Figure 9.7
1. Turn the Battery switch  to off (see Figure
9.7).
Figure 9.8
2. At the ground control box set the
EMERGENCY STOP switch € to off, turn
the MAIN POWER switch  off and remove
the key ‚ (see Figure 9.8).
page 9 - 2 Rev A SR3370 & SR2770 – 13184A
9. Emergency Operation
DANGER