Snorkel X52RT-sn10000+ - Manual (Page 24)

OPERATOR’S MANUAL with Maintenance Information
Function Tests
19
At the Platform Controls
Test Emergency Stop
16 Push in the platform red Emergency Stop
button to the off position.
☉ ☉ ☉ ☉ Result: No functions should operate.
17 Pull the red Emergency Stop button out to
the on position.
☉ ☉ ☉ ☉ Result: The LED indicator light should come
on.
Test the Horn
18 Push the horn button.
☉ ☉ ☉ ☉ Result: The horn should sound.
Test Up/Down Functions and Function
Enable
19 Start the engine.
20 Activate the up/down rocker switch in the
direction indicated by the up arrow.
☉ ☉ ☉ ☉ Result: The platform should not raised.
21 Push and hold the lift function enable
button.
22 Activate the up/down rocker switch in the
direction indicated by the up arrow.
☉ ☉ ☉ ☉ Result: The platform should raise.
23 Push and hold the lift function enable
button.
24 Activate the up/down rocker switch in the
direction indicated by the down arrow.
☉ ☉ ☉ ☉ Result: The platform should lower. The
descent alarm should sound while the
platform is lowering.
Test the Steering
Note: When performing the steer and drive
function tests, stand in the platform facing the
steer end of the machine.
25 Press and hold the function enable switch
on the control handle.
26 Depress the thumb rocker switch on top of
the control handle in the direction identified
by the left triangle on the control panel.
☉ ☉ ☉ ☉ Result: The steer wheels should turn in the
direction that the left triangle points on the
control panel.
27 Depress the thumb rocker switch in the
direction identified by the right triangle on
the control panel.
☉ ☉ ☉ ☉ Result: The steer wheels should turn in the
direction that the right triangle points on the
control panel.
Test Drive and Braking
28 Press and hold the function enable switch
on the control handle.
29 Slowly move the control handle in the
direction indicated by the up arrow on the
control panel until the machine begins to
move, then return the handle to the center
position.
☉ ☉ ☉ ☉ Result: The machine should move in the
direction that the up arrow points on the
control panel, then come to an abrupt stop.
30 Press and hold the function enable switch
on the control handle.
31 Slowly move the control handle in the
direction indicated by the down arrow on the
control panel until the machine begins to
move, then return the handle to the center
position.
☉ ☉ ☉ ☉ Result: The machine should move in the
direction that the down arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.