Snorkel XRT33 Electric-sn1001+ - Manual (Page 7)

7 XRT Electric
E LEVATING THE P LATFORM
1. Select a firm, level surface.
2. Turn the Lift/Drive Switch to LIFT.
3. Engage the Interlock Switch and push the Control Handle forward.
4. If the machine is not level, the tilt alarm will sound and the machine will not lift or drive. If the
tilt alarm, sounds the platform must be lowered and the machine moved to a firm, level
surface before attempting to re-elevate the platform.
T RAVEL WITH W ORK P LATFORM E LEVATED
NOTE: The machine will travel at reduced speed when the platform is elevated.
1. Check that the route is clear of obstacles (persons, obstructions, holes, drop-offs, bumps, and
debris), is level, and capable of supporting the wheel loads.
2. Check clearances above, below, and to the sides of the platform.
3. Turn the Lift/Drive Switch to DRIVE.
4. Set the Speed Range Selector Switch to the HIGH SPEED position.
5. Engage the Interlock Switch and move the Control Handle to FORWARD or REVERSE to
travel in the desired direction. The speed of the machine will vary depending on how far from
center the Control Handle is moved.
6. If the machine is not level, the tilt alarm will sound and the machine will not lift or drive. If the
tilt alarm sounds, the platform must be lowered and the machine moved to a firm, level
surface before attempting to re-elevate the platform.
L OWERING THE P LATFORM
1. Turn the Lift/Drive Switch to LIFT.
2. Engage the Interlock Switch and pull back on the Control Handle to lower the platform.