Drive motion alarm 7-9, Driving and work lights 7-9, Platform control cover 7-9 – Snorkel TB37 2001 User Manual
Page 33: Tow kit 7-9, Placards and decals 7-9, Ground fault circuit interrupter, 7-9, Reset button, 7-9, Test button, 7-9, Drive motion alarm, 7-9, Platform control cover, 7-9
Figure 7.23—Upper Control Panel Front
Plug an electrical tool into the receptacle at the platform
and at the generator and try to operate the tool to verify
proper operation of the outlet.
The outlet is equipped with a ground fault circuit inter-
rupter (GFCI). Use the following procedure to test the
GFCI.
1. Push the black test button (refer to Figure 7.24).
Figure 7.24—Electrical Power Outlet
2. Plug an electrical tool into the outlet and verify the
power is off.
●
If the power was off, push the reset button to
restore power.
●
If the power was on, repair or replace the
receptacle.
Drive Motion Alarm
The machine may be equipped with an optional drive
motion alarm. Drive in both the forward and reverse di-
rections to ensure that the alarm sounds to warn per-
sonnel in the area that the aerial platform is in motion.
Driving and Work Lights
The machine may be equipped with driving lights and/or
platform working lights. Turn the engine on and use the
switch on the back of each light to momentarily turn it on
to see that it works.
Platform Control Cover
The machine may be equipped with an optional plat-
form control cover. Inspect the cover to ensure it fits
properly over the control panel.
Tow Kit
The machine may be equipped with an optional tow kit.
Inspect the tow bar and steering arm to verify the com-
ponents are present and in working condition.
Placards and Decals
Inspect all safety and operational placards and decals.
Make certain they are in place, in good condition, and
are legible.
The placards and decals may be cleaned with soap and
water, and a soft cloth if the words or pictures cannot be
seen.
Solvents may contain hazardous ingredients. Fol-
low the manufacturer’s label for proper use and dis-
posal. Wear protective gloves and splash-proof
safety glasses when using solvents.
Wet paint overspray may be removed using a natural
biodegradable solvent and a soft cloth.
Replace any missing or illegible placards or decals be-
fore operating the aerial platform. Placard and decal kits
are available from Snorkel dealers.
The safety related placards and decals are illustrated
on the following pages.
Chapter 7. Prestart Inspection
TB37 – 0172094
page 7 - 9
CAUTION
Reset Button
Test Button
Machine/Generator Switch