Caution – Snorkel TB66J CE User Manual

Page 27

Advertising
background image

Chapter 6 – Controls

TB60/66J – 0084030EE

23

Figure 6.5 – Upper Control Panel Top

Start Switch

The engine can be started from the platform using the

anti-restart master switch on the front of the upper con-

trol panel (refer to Figure 6.4).

This switch is similar to an automobile ignition switch.

Turn the switch to start until the engine starts, then

release it to on. If the engine dies, the switch must be

turned to off before it can be turned back to start.

An alarm sounds when the switch is turned on to warn

others that the machine engine is being started.

Note

On some machines it may be necessary to pause about

three seconds in the on position before going to start so

the starter can engage.

Turn the switch to off to turn the engine off and save

fuel if the platform is to stay in a particular position for

a long time.

Emergency Stop Button

The emergency stop is a two-position, red push button

on the top of the upper control panel (refer to Figure

6.5). Push the button in to disconnect power to all con-

trol circuits at the upper controls. Pull the button out to

restore power.

Note

The lower controls override the upper controls. If the

upper control emergency stop button is engaged the

lower controls can still be used to operate the aerial

platform.

Push the emergency stop button in when the upper

controls are not in use to protect against unintentional

operation.

Figure 6.4 – Upper Control Panel Front

The circuit breakers protect the electrical wiring and

components from electrical overload in case of a short

circuit or other fault.

A

Caution

A tripped circuit breaker indicates a malfunction in

the electrical system. Component damage can result

if the cause of the malfunction is not corrected. Do

not operate the aerial platform if the circuit breaker

trips repeatedly.

Push the button to reset the circuit breaker.

Upper Controls

The upper controls (refer to Figure 6.5) are located on

the control panel at the platform. Boom, platform, and

drive functions can be operated from the upper controls.

The following controls are located on the upper control

panel.

• Start switch

• Emergency stop button

• Speed knob

• Drive/boom selector switch

• Boom joystick

• Drive joystick

• Drive range switch

• Jib articulation switch – TB66J only

• Platform level switch

• Boom extend/retract switch

• Engine/emergency power switch

• Throttle switch

• Platform rotate switch

Engine

Throttle

Platform

Level

Engine/Emergency

Power

Boom Extend/

Retract Switch

Drive Range

Speed

Knob

Jib Switch

Emergency Stop

Boom Joystick

Platform Rotate

Drive/Boom

Selector

Drive Joystick

Start Switch

Circuit Breaker Reset Buttons

Advertising
This manual is related to the following products: