Barco CORONIS MFGD 3621 - Manual (Page 34)

B
ARCO
M
ED
C
ORONIS
display controller installation
34
DVI cable. For a dual-headed BarcoMed Coronis setup, connect the
secondary display to the other connector on the display controller.
7. Replace the chassis cover, reconnect the power cord, turn on the
power, and boot the system as usual.
Running multiple BarcoMed Coronis display controllers in a single host
The physical order of the displays may vary when you are running
multiple
BarcoMed Coronis display controllers. This is due to the PC’s PCI
bus control in the system BIOS, and not the BarcoMed display controller.
It may become necessary, depending on how your PC’s BIOS configures
the PCI bus, to switch your DVI display connections to achieve a linear
desktop configuration.
Figure 6: The Video Outputs.