Eppendorf Mastercycler pro - Manual (Page 21)

Installation
Mastercycler pro
English (EN)
21
4 Installation
4.1 Unpacking the device
1. Release the four plastic locking clips at the long sides of the carton by pulling out the flaps.
2. Lift the carton lid and take the foam upper part off the Mastercycler pro.
3. Take the carton insert out of the carton lid (contains the mains cable).
4. Take the Mastercycler pro out of the plastic bag.
5. With both hands, hold the Mastercycler pro by the lower half of the housing and lift it out of the
package.
6. Remove all the packing material.
7. Visually check the device to ensure that no damage has occurred during shipment.
8. Check the completeness of the delivery (see Delivery package on p. 11).
WARNING! Risk of injury when lifting and transporting the device.
Lifting the device with the wrong posture may cause serious damage to your health. If the
device falls to the ground it can cause injuries.
 Do not lift the device by the handle or the housing of the heated lid.
 Carry the device securely with both hands to prevent it from slipping.
 Always keep a straight back when lifting and carrying the device.
Never use a device if it shows any signs of damage. In this case, contact your distributor or the
appropriate Eppendorf office.
• Retain the packing material for shipping or storing the Mastercycler pro at a later date.
• Ship the Mastercycler pro only in the original packing material.